Test and Measurement Forum

pt100 without pt104?

Which product is right for your exact requirements

pt100 without pt104?

Postby tretlo » Fri Jan 19, 2007 7:39 pm

Hello and thanks for this great forum.

I am interested in using the pt100 to measure temperature in a custom circuit with a PIC microcontroller. In this case, my PIC software would have to convert the probe resistance, via an ADC, to temperature. I would therefore presumably have no need for the pt104, correct?

My question has two parts.

1) Is a schematic or other documentation available for a recommended input circuit for the pt100? In other words, how do you suggest I convert the probe resistance to a voltage that can be fed to an ADC? Any information regarding suggested analog design would be helpful.

2) Do you have any suggestions for the routine to convert the digitized resistance measurement to temperature? I did notice the linearization equation on your website, but I was wondering if further implementation recommendations are available.

I am basically hoping to emulate parts of the pt104 functionality in my own design so I can easily integrate the measurements into a larger control system. If it goes well, we may be purchasing many probes.

Thanks in advance for your help,
Ryan
tretlo
Newbie
 
Posts: 1
Joined: Fri Jan 19, 2007 7:21 pm

Postby davidj » Tue Jan 23, 2007 4:01 pm

Hello Ryan

Thanks for the good comments.

We suggest you take a look an an ADC aimed at PT100 / RTD measurements such as this one:

http://tinyurl.com/2jcpqs

see P39. Also a few pages up from this there is some C code which may be of interest.
Regards,
David
davidj
Site Admin
Site Admin
 
Posts: 43
Joined: Wed Oct 11, 2006 8:50 am
Location: St. Neots, Cambs, UK


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests