adc212

Which product is right for your exact requirements
Post Reply
htku

adc212

Post by htku »

hello
we are interested of using adc212/3 to acquire data of following
like
1)vibration of automotive engine, pls advise sensor which suitable
2)noise of car engine in Db unit
3)simple way to connect to temperature measurement ..converter pls recommend .preferable K type termocouple
it will appreacited if brief how to interface to adc212 :o

wilfred

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

Unfortunately, we do not produce the sensors that you require to measure vibration or noise. You will have to source these from a third party, such as rs or farnell:
www.rswww.com
www.farnell.com

To measure temperature you will need a signal conditioner that can use k type thermocouples... but again we are unable to provide this signal conditioner.

Instead of using the ADC212-3, you might consider using our TC-08 which is specifically designed for this purpose. This unit uses Picolog software and is a datalogger, which can measure temperatures in the range -270 deg C to +1800 deg C depending on the thermocouple type used.

Best regards,
Regards,

Mark Spencer

Guest

Re: adc212

Post by Guest »

hi
i having Adc 212/3 use for continue logging data,kindly advise the power in watt require to run the unit especial main supply is out >
htku
htku wrote:hello
we are interested of using adc212/3 to acquire data of following
like
1)vibration of automotive engine, pls advise sensor which suitable
2)noise of car engine in Db unit
3)simple way to connect to temperature measurement ..converter pls recommend .preferable K type termocouple
it will appreacited if brief how to interface to adc212 :o

wilfred

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

The ADC212/3 requires approximately 3.024 watts., when both channels are in use. From a 12 volt supply.

Best regards,
Regards,

Mark Spencer

Post Reply