Automation with multiple scopes

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
jackdigitalinsight
Newbie
Posts: 0
Joined: Sat Jul 15, 2017 9:17 pm

Automation with multiple scopes

Post by jackdigitalinsight » Sat Jul 15, 2017 9:28 pm

I have two 4444 scopes running (s/w 6.12.2687) on one PC. Is there a way to direct command-line automation ("picoscope /a ...") to a specific running instance?

I know the SDK allows opening specific devices, but I'd like the pretty trace graphs that the PicoScope GUI application creates rather than just capturing raw data and building the graph myself, not to mention using the GUI to configure settings.

Also, is there any documentation beyond the "picoscope /a ?" output, or at least a way to get help on specific commands?

Thanks.

Hitesh
Site Admin
Site Admin
Posts: 2810
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Automation with multiple scopes

Post by Hitesh » Mon Jul 17, 2017 8:15 am

Hi Jack,

Could you please e-mail support@picotech.com in order to discuss this further please?

In terms of further information, this post shows the command to use to find the list of available automation commands.

Regards,
Hitesh

Technical Support Engineer

Post Reply