I'm trying to modify your ps3000acon.c program to save digital port data instead of analogue channel data, but I'm having no success - the samples that I receive from the Piscoscope are always analogue channel data.
I wondered if you had an example that showed how to recover digital port data in Rapid Block Mode instead of analogue channel data, or if you could offer me any advice on how to do this please.
Recovering Digital Port Data using Rapid Block Mode
Re: Recovering Digital Port Data using Rapid Block Mode
Hi kmorfitt,
Would it be possible to confirm if you have done the following please:
Regards,
Would it be possible to confirm if you have done the following please:
- Called ps3000aSetChannel() to turn off all analogue channels
- Called ps3000aSetDigitalPort() to enable the required digital port (a bank of 8 digital channels)
- Set up a trigger on digital channels
Regards,
Hitesh
Technical Support Engineer
Technical Support Engineer