Test and Measurement Forum

Possibility to use scope without USB Connection

Post any questions you may have about our current range of oscilloscopes

Possibility to use scope without USB Connection

Postby NetoLE » Thu Jun 08, 2017 7:21 am

Hello!

My question is if it is possible to use the scopes (in my case 3000 series) without any cable-connection to the PC.

A scenario would be: configure the scope with picoscope software to capture with a trigger, disconnect the USB let the scope run, connect the cable later, get the captured scope.

This would be a scenario where you need to log captures from a moving platform like in the industry.

I came up with the question because there is always mentioned the big memory inside the scopes and in the API-documentations there is also mentioned a block-wise operation, where whole blocks are saved in the internal memory.

Thanks for the answers
Felix
NetoLE
Newbie
 
Posts: 0
Joined: Wed Feb 01, 2017 12:43 pm

Re: Possibility to use scope without USB Connection

Postby Martyn » Thu Jun 08, 2017 7:28 am

No, all of our PicoScopes need to be connected to the PC to operate.
Martyn
Technical Support Manager
Martyn
Site Admin
Site Admin
 
Posts: 2716
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 1 guest