Test and Measurement Forum

Which Picoscope for 1-wire analysis

Which product is right for your exact requirements

Which Picoscope for 1-wire analysis

Postby micksulley » Mon May 29, 2017 9:34 pm

I need a scope to analyse a problem with a 1-wire network. I have found an article on this site
https://www.picotech.com/library/oscill ... l-decoding
explaining how to do it but I am unsure which model picoscope I need. Will any of them do the job?
Also I would like to run it on Linux Mint, is there any problem with that? If absolutely necessary I could use XP, but prefer not to.

Thanks
Mick
micksulley
User
User
 
Posts: 2
Joined: Mon May 29, 2017 9:26 pm

Re: Which Picoscope for 1-wire analysis

Postby Gerry » Thu Jun 01, 2017 2:14 pm

Hi micksulley,

Any model PicoScope should be able to decode 1-wire (the data rate is not particularly fast). The limiting factor is going to be, how much data do you need to decode in one capture session (how much communication do you need to diagnose the problem)? The amount that you can capture in one go will depend on the size of the PicoScope models hardware buffer. You can use the Oscilloscope comparison tool (see here: https://www.picotech.com/products/oscil ... ifications) to compare the buffers of different models.

The Linux version of PicoScope 6 should run on Linux Mint O.K. (see here for accessing it: https://www.picotech.com/downloads/linux) and supports 1-wire (see here: topic19011.html).

Regards,

Gerry
Gerry
Technical Specialist
Gerry
PICO STAFF
PICO STAFF
 
Posts: 130
Joined: Mon Aug 11, 2014 11:14 am


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests