Test and Measurement Forum

Auto setting on 3204 Y-axis

Forum for discussing PicoScope (version 5)

Auto setting on 3204 Y-axis

Postby Billton » Wed Oct 18, 2006 8:58 pm

I've just installed a new 3204 and noticed that the Auto setting for the Y-scale doesn't reset itself when Picoscope uses an external trigger source. This is a pain because I would like to measure the voltage of a signal that gradually increases to a point and then is turned off. With the Auto setting working the signal would reset to a measurable level, without it it goes off the screen.
Billton
 

Postby Michael » Fri Oct 20, 2006 8:55 am

Hello,

Thank you for reporting this.

I will check this out and pass to our software developers. Please check our webiste and newsletter for software updates.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum
Michael
Zen Master
Zen Master
 
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire


Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests