TC-08 with LabView - beginning with 2UnitSelect.vi

Post your LabVIEW discussions here
Post Reply
AngelaM
Newbie
Posts: 0
Joined: Wed Feb 08, 2017 2:06 pm

TC-08 with LabView - beginning with 2UnitSelect.vi

Post by AngelaM »

HI,

Just starting off using the VI 2UnitSelect.vi in LabView, but do not have any previous experience using LabView. For some reason when I run this vi I get a window popping up stating "No Desired Units match Unit B" and the same for Unit A. It detects the two TC-08 dataloggers, but I get this message. I assumed that the user has to input a number in the 'Desired Unit Number' box for each datalogger to differentiate between the two, and therefore put numbers 1 and 2 for each datalogger, but I still got the same error.

Apologies if this has come up before. I'm assuming there is a very basic answer :? , but have not been able to get it to work so far.

Many thanks,

Angela

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: TC-08 with LabView - beginning with 2UnitSelect.vi

Post by Martyn »

Have you tried putting the serial numbers in the boxes. These are the numbers under the barcode on the bottom of the devices.
Martyn
Technical Support Manager

AngelaM
Newbie
Posts: 0
Joined: Wed Feb 08, 2017 2:06 pm

Re: TC-08 with LabView - beginning with 2UnitSelect.vi

Post by AngelaM »

Great, thanks :D That worked. Was just a bit confused because it seemed to ask for a desired unit number.

Post Reply