Is it possible to do math with measurements?

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
JPortici
Newbie
Posts: 0
Joined: Wed Dec 28, 2016 10:05 am

Is it possible to do math with measurements?

Post by JPortici » Wed Dec 28, 2016 10:13 am

Hi!
I was wondering if it was possible to do math with measurements.
For example:
Signal is a pulse train with variable duty cycle/high cycle time, an MCU modifies the duty cycle/high cycle time (by adding a percentage OR a time)
I have the corresponding measurements from channel A and B, but to see if the signal alteration is consistent with frequency etc i have to change frequency, stop, do the math by hand, repeat.

Martyn
Site Admin
Site Admin
Posts: 3375
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Is it possible to do math with measurements?

Post by Martyn » Wed Dec 28, 2016 11:59 am

Try adding a Maths channel for duty cycle and frequency

Duty(A)

Frequency(A)
Martyn
Technical Support Manager

Post Reply