Test and Measurement Forum

Trigger with a value decoded by serial decoder

Forum for discussing PicoScope version 6 (non-automotive version)

Trigger with a value decoded by serial decoder

Postby rik » Thu Dec 22, 2016 7:06 pm

Hi, due to poor eyesight I like very much the big screen of my pc compared to the very small screen of "old" scope (not USB), but in the last month I used my Picoscope 2208A to develop and debug some bidirectional (half duplex) protocol. My problem is that with also a very low cost scope like Rigol DS1104Z I can set the trigger on a specific numeric value of the RS232 decoder. But I don't like to work with eyeglass on a so small screen. May be that in future, is possible with a firmware update to set for trigger a value decoded by the serial decoders of 2208A?
rik
Newbie
 
Posts: 0
Joined: Thu Dec 22, 2016 5:41 pm

Re: Trigger with a value decoded by serial decoder

Postby Martyn » Wed Dec 28, 2016 1:47 pm

Hardware serial data triggering is not currently being considered, and may be too difficult to implement in the available code space whilst still supporting the other device features. However filtering by specific data in the decode table, offers a way of searching for information of interest.
Martyn
Technical Support Manager
Martyn
Site Admin
Site Admin
 
Posts: 2686
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 1 guest