Test and Measurement Forum

Any way to invert pattern on 2202 ?

Forum for discussing PicoScope (version 5)

Any way to invert pattern on 2202 ?

Postby ideal1 » Sun Sep 03, 2006 11:35 pm

Is there a way to invert the pattern or switch polarity on the 2202 scope?
I would like to use it for secondary ignition but pattern is upside down. If I reverse probe leads the pattern gets deformed and erratic. Can it be done with custom ranges?
ideal1
User
User
 
Posts: 2
Joined: Sun Sep 03, 2006 11:17 pm
Location: New Jersey

Ranges

Postby Autonerdz » Mon Sep 04, 2006 8:37 pm

The PicoScope Automotive software has these ranges already configured along with a lot of other automotive specific resources and settings. However, your 2202 is not an automotive scope and the automotive software version is not compatible. You will have to make your own custom ranges for conventional secondary based on the probe attenuation and inverting the scaled output to turn the pattern over.
Tom Roberts
(The Picotologist)
http://www.autonerdz.com
skype: autonerdz
THE PicoScope Automotive Authority
In North America
User avatar
Autonerdz
Guru
Guru
 
Posts: 141
Joined: Wed Nov 20, 2002 4:19 pm
Location: Washington State USA

Ranges

Postby ideal1 » Tue Sep 05, 2006 10:13 pm

Thanks. I was playing with the custom ranges today and was able to get a good stable right side up pattern on 2000 chev 6.0L and 98 Linc with COP.
ideal1
User
User
 
Posts: 2
Joined: Sun Sep 03, 2006 11:17 pm
Location: New Jersey


Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests