Crashes attempting to trigger on digital channel

Discussion forum for the new Picoscope Linux software
Post Reply
djarvie
Newbie
Posts: 0
Joined: Tue Nov 08, 2016 4:28 pm

Crashes attempting to trigger on digital channel

Post by djarvie » Tue Nov 08, 2016 4:41 pm

I configured an LVCMOS 3.3V digital channel (D0), and then attempted to set an advanced trigger on it. When Pulse Width or Interval is selected, and then D0 is selected as the source, Picoscope reliably crashes within a couple of seconds.

I tried running it from a terminal, but it didn't output any stack trace.

Picoscope 6.11.13.3, running on Fedora 23.
Using with PicoScope 3406D MSO.

Martyn
Site Admin
Site Admin
Posts: 3333
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Crashes attempting to trigger on digital channel

Post by Martyn » Fri Nov 18, 2016 9:52 am

If you can repeat the issue and then send in the trace.xml file in the following location:

~/.local/share/Pico\ Technology/260a68f1-30f-0a5e01d65514

and send this to support@picotech.com
Martyn
Technical Support Manager

Post Reply