Test and Measurement Forum

Pulsing signal generator

Post general discussions on using our drivers to write your own software here

Pulsing signal generator

Postby anton » Fri Jul 28, 2006 1:05 pm

Is there any way that we can use the ADC212 to generate a pulsing signal and record it on the other channel. The option from picoscope will only allow me to generate square wave without any further option. I need the signal for say 2ms and repeat again after 1 second.
anton
 

Postby Michael » Mon Jul 31, 2006 10:25 am

Hello,

The signal generator on our scopes is limited only to the available modes.

YOu will not be able to change the functionality of these waveforms.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum
Michael
Zen Master
Zen Master
 
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 1 guest