BNC inputs CAT I/II/III

Post any questions you may have about our current range of oscilloscopes
Post Reply
Guest

BNC inputs CAT I/II/III

Post by Guest » Thu Jun 22, 2006 6:46 pm

Hi there...

We are looking at getting a portable scope for field work. We measure powerline stuff... like rf over powerline in the 150KHz range... but we also need input voltage protection too. I was wondering if the inputs on the 3206 for example was CATI CATII or CATIII rated like desktop scopes?
What is the maximum voltage you can measure with a 1x probe? etc etc.
Think these products are suitable?
Also when not in the field, we'd be doing development work, standard PIC chip stuff with dsPICs.

Jeff

Michael
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael » Fri Jun 23, 2006 9:57 am

Hello,
At present, our scopes do not conform to CATI, II & III standards. Our differential input probe is CATIII rated for your safety. YOu will be able to measure high voltages with this probe.

Further information can be found her:
http://accessories.picotech.com/oscillo ... robes.html

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum

Post Reply