PicoScope 7 Software
Available on Windows, Mac and Linux
Installing and configuring software for ADC11
Installing and configuring software for ADC11
Hi guys,
I am trying to install and configure PicoScope and PicoLogg Recorder for an pico ADC-11.
I have followed the instructions from the ADC-11/ADC-20 user guide (I have also copied the adc1132.dll file as specified in chap. 3.2 of the manual) [filename: adc11-en-2.pdf] and installed PicoScope and PicoLog Recorder which I have downloaded from https://www.picotech.com/downloads (Discontinued Products -> ADC-11 -> software). I have also installed the drivers (a .rar file) for ADC-11 from https://www.picotech.com/discontinued (Data Loggers -> ADC-11 -> Recourses).
Inside the .rar file there is a PICOreadme.txt file which gives further instruction on how to install the drivers.
Following the steps I have done the following:
1) USB drivers
Copy picopp.inf to\inf
Copy picopp.sys to\system32\drivers
Plug the device in and follow the new hardware wizard.
2) Parallel port drivers
Copy pico.sys to\system32\drivers
use regdrive with the pico option to install the driver service:
c:\> regdrive.exe pico
When running Picosocpe I get this message: "the file adc1132.dll failed to load correctly"
When connecting ADC-11 to my computers USB port the drives fail to install and my ADC-11 is not recognized neither by PicoScope nor PicoLog Recorder.
I am running Windows 7 professional, service pack 1.
Any help would be highly appreciated.
I am trying to install and configure PicoScope and PicoLogg Recorder for an pico ADC-11.
I have followed the instructions from the ADC-11/ADC-20 user guide (I have also copied the adc1132.dll file as specified in chap. 3.2 of the manual) [filename: adc11-en-2.pdf] and installed PicoScope and PicoLog Recorder which I have downloaded from https://www.picotech.com/downloads (Discontinued Products -> ADC-11 -> software). I have also installed the drivers (a .rar file) for ADC-11 from https://www.picotech.com/discontinued (Data Loggers -> ADC-11 -> Recourses).
Inside the .rar file there is a PICOreadme.txt file which gives further instruction on how to install the drivers.
Following the steps I have done the following:
1) USB drivers
Copy picopp.inf to
Copy picopp.sys to
Plug the device in and follow the new hardware wizard.
2) Parallel port drivers
Copy pico.sys to
use regdrive with the pico option to install the driver service:
c:\> regdrive.exe pico
When running Picosocpe I get this message: "the file adc1132.dll failed to load correctly"
When connecting ADC-11 to my computers USB port the drives fail to install and my ADC-11 is not recognized neither by PicoScope nor PicoLog Recorder.
I am running Windows 7 professional, service pack 1.
Any help would be highly appreciated.
-
Hitesh
Re: Installing and configuring software for ADC11
Hi benxyp09,
If your Windows 7 operating system is a 64-bit version then the ADC-11 will not work and you will need a 32-bit operating system.
When you installed the PicoLog Recorder software, was the adc1132.dll file present in the installation directory?
Regards,
If your Windows 7 operating system is a 64-bit version then the ADC-11 will not work and you will need a 32-bit operating system.
When you installed the PicoLog Recorder software, was the adc1132.dll file present in the installation directory?
Regards,