Hi,
Can one instance of the pico oscilloscope software run two PicoScope 2104 from the same pc at the same time?
If so can you trigger off one to capture the waveform from the other? -
In other words can you use two 2104's as you would a normal dual channel pico scope, triggering off one channel to capture a signal on the other?
Running two PicoScope 2104
Hi mpgreen,
I'm afraid this is not possible, the Pico oscilloscope software will only allow you to use one unit at a time. The only way of doing this will be with a dual channel scope.
Please let me know if you have any further questions.
Best regards,
Ric
I'm afraid this is not possible, the Pico oscilloscope software will only allow you to use one unit at a time. The only way of doing this will be with a dual channel scope.
Please let me know if you have any further questions.
Best regards,
Ric
Ricardo Paloschi
Sales Engineer
Forum Moderator
Sales Engineer
Forum Moderator
Need four channels at 200MHz
Hi,
I was looking at the specs for your scopes. I noticed that your 4 channel has an extremely slow bandwidth (for my application anyway), however, your PICO 3206 has an adecuate bandwidth, but too few channels. Could it be possible to run two 3206 scopes with one instance of your software?
I was looking at the specs for your scopes. I noticed that your 4 channel has an extremely slow bandwidth (for my application anyway), however, your PICO 3206 has an adecuate bandwidth, but too few channels. Could it be possible to run two 3206 scopes with one instance of your software?