Test and Measurement Forum

ADC-11 USB and "adc11_run not found" problem

Post general discussions on using our drivers to write your own software here

ADC-11 USB and "adc11_run not found" problem

Postby mirekb » Thu Mar 30, 2006 11:06 am

Hi,
I just bought ADC-11 and I try to make it work. Picoscope goes Ok, but when I try to use it with VB or Excel macro it doesn't work. It "opens" port 1 (LPT1?) but it doesn't show the right values. When I set 101...109 port (as I read for USB shoud be) he cannont open the device.

Even he tells me adc11_run routine not defined.
What is wrong?
I wait for your responde.
Mirek
mirekb
 

Strange

Postby mirekb » Thu Mar 30, 2006 8:48 pm

I wonder why pico sells and gives to download a software without a documentation. I passed hours to search something on the net.
1. USB port number is 101
2. Device number is 111 and not 11 (it wasn't so simple to find that out)
3. There are some routines not defined...
4. And so on.

I did cope with this, but why did I have to make all this reseach? I'm not even sure if this is the end.

Mirek
mirekb
 

Postby Sarah » Fri Apr 07, 2006 9:54 am

Hi

My apologies that you were unable to find the documentation. It should be installed with the download and is also available on our website at:

http://www.picotech.com/document/document.html

Best Regards
Sarah
 


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests