Record result of measurement after capture

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Posts: 0
Joined: Wed Mar 16, 2016 4:41 pm

Record result of measurement after capture

Post by james.holmes » Wed Mar 16, 2016 4:53 pm

I have a Picoscope 3204A reading voltages and integrating them. I'm using a 'Measurement - Maximum' to read the final integrated value over the time period before starting the process again to capture the next sample.

I see that I can trigger an alarm on a successful capture which can cause a beep, record the entire dataset or launch an executable, but how do I simply record the measured value to a file? i.e. "2.437 V".

In the past I've used Picolog but I don't think it's supported for this scope?

Thanks for any help,


Posts: 2855
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Record result of measurement after capture

Post by Hitesh » Thu Mar 17, 2016 2:01 pm

Hi James,

You can export the Measurement data to a file using a command prompt window - please refer to this post.

Unfortunately, the PicoScope 3204A is not supported by the PicoLog software.


Software Dev. Engineer

Post Reply