Hello, I'm new user of linux and Idon how to install it.

Discussion forum for the new Picoscope Linux software
Post Reply
Richar
Newbie
Posts: 0
Joined: Tue Mar 08, 2016 1:30 am

Hello, I'm new user of linux and Idon how to install it.

Post by Richar » Tue Mar 08, 2016 2:12 am

I've a picoscope 2203 unit and I'll use linux, after load the driver from the page I'can't start the aplication how I can to do it? wat I need?

Hitesh
Site Admin
Site Admin
Posts: 2845
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Hello, I'm new user of linux and Idon how to install it.

Post by Hitesh » Wed Mar 09, 2016 1:50 pm

Hi Richar,

Have you installed the Mono package for your Linux operating system?

Did you follow the instructions for your Linux version from the Linux Software & Drivers for Oscilloscopes and Data Loggers page, and if so which specific instructions did you run?

If the PicoScope 6 application has installed, do you see the splashscreen or do you see any reports in the terminal window when you type picoscope and press ENTER?

Regards,
Hitesh

Technical Support Engineer

Post Reply