Scaling the x-axis in spectrum view

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
siepmann
Newbie
Posts: 0
Joined: Wed Dec 09, 2015 5:59 pm

Scaling the x-axis in spectrum view

Post by siepmann » Fri Dec 11, 2015 4:00 pm

Hello !

I openend the demo (scope view) and added a spectrum view.
Unfortunateley I don't see anything of the spectrum (1 kHz) because
the x-axis is scaled from 0 to 10 MHz and the signal disappears
at the left border.

I didn't find a possibility to scale the x-axis of the scope view
separately. How can I do this?

Thank you for help!

Jürgen

Hitesh
Site Admin
Site Admin
Posts: 2829
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Scaling the x-axis in spectrum view

Post by Hitesh » Mon Dec 14, 2015 11:51 am

Hi Jürgen,

You should be able to adjust the frequency range by using the drop-down List box as shown in the image below.
Spectrum_axis.PNG
Spectrum view
Hope this helps.
Hitesh

Technical Support Engineer

siepmann
Newbie
Posts: 0
Joined: Wed Dec 09, 2015 5:59 pm

Re: Scaling the x-axis in spectrum view

Post by siepmann » Mon Dec 14, 2015 1:45 pm

PicoScope 6 Beta.png
scope and spectrum view
Hi Hitesh,

but this is not working if you open a second window with
a spectrum view.

Jürgen

Martyn
Site Admin
Site Admin
Posts: 3345
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Scaling the x-axis in spectrum view

Post by Martyn » Wed Dec 16, 2015 11:03 am

When you have two views open, one will be the primary view, and this is the one that defines how the scope is set up.

If the primary view is the time domain, as in your example, it is not possible to change any of the settings for the secondary spectrum view. You can zoom in to see more detail if you wish to.
Martyn
Technical Support Manager

Post Reply