Test and Measurement Forum

a question about picoscope 3206

Post any questions you may have about our current range of oscilloscopes

a question about picoscope 3206

Postby m_vincent » Sat Nov 05, 2005 7:25 am

Good morning, i would like to buy a picoscope 3205 but i have a question before, it’s specified that the 3206 have a 100MS/s in dual channel mode and a 200MS/s in the single channel mode, but for the 3205 the 100MS/s is for wich mode? Single or dual channel mode?
Thank for your answer
Best regards
m_vincent
User
User
 
Posts: 3
Joined: Sat Nov 05, 2005 7:23 am

Postby Sarah » Tue Nov 08, 2005 9:41 am

Hi

Thank you for your post.

The 100MS/s is for one channel. If you use 2 channels then the maximum becomes 50MS/s for each channel.

Hope this helps

Best Regards
Sarah
 

Postby m_vincent » Thu Nov 10, 2005 1:51 pm

Hi, thanks for your reply, but after visiting the Pico Web site, i have found the user manual for Picoscope in PDF format, so after read it, i have see in this document the specification, and it's specified that for the 3205 the sampling rate is 100MS/s if one OR two channel are used. So this information is not compliant with what you says, can confirm which one is correct or if i have no understand something?

Thanks in advance
(Sorry if my english is not so good as yours but i'm french)

Best regards
m_vincent
User
User
 
Posts: 3
Joined: Sat Nov 05, 2005 7:23 am

Postby Michael » Fri Nov 11, 2005 9:49 am

Hello,

The 3204 and 3205 both maintain the high sampling rate for one and two channels. The 3206 will divide the sampling rate for two channels.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum
Michael
Zen Master
Zen Master
 
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests