Test and Measurement Forum

Failed to find ADC16 when RF enabled

Forum for discussing PicoLog

Failed to find ADC16 when RF enabled

Postby Winston » Wed Oct 12, 2005 12:04 pm

I have an application where I need to log data remotely. I used a type of wireless modem to relay data wirelessly. First I used two computers both connected with the wireless modems and they can communicate via Hyperterminal at baud rate 57600 bps, which is the com setting of two computers. Then I connect ADC16 with one wireless modem, seperately powered up ADC16 with +- 5V power supply. PicoLog then failed to find ADC16 but I can see from the LEDs on the wireless modem that the two have communicated with each other. I assume there is a timeout window in your PicoLog, during which a reponse from ADC16 is expected. If this is correct, is there any possibility this timeout window can be extended?

Another test I did then is to connect ADC16 directly with computer and seperately power up ADC16 with +- 5V power supply, PicoLog find it straight away.



Postby Michael » Thu Oct 13, 2005 9:00 am


I will reply to your post by email.

Best regards,
Michael - Tech Support
Pico Technology
Web Support Forum
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Return to PicoLog

Who is online

Users browsing this forum: No registered users and 1 guest