Test and Measurement Forum

Trigger based on two channels at a time

Forum for discussing PicoScope version 6 (non-automotive version)

Trigger based on two channels at a time

Postby Jean-Marc » Tue Sep 08, 2015 12:02 pm

Hi,
I came across a case where I did not find the triggering mode I needed.
I wanted to check that the delay between the edge of the signal in one channel and the edge of another signal in another channel is within specs.
Thus, I needed to be able to trigger if the time between the edge (rising or falling, selectable) of channel A and the edge (rising or falling, selectable) of channel B, is between a minimum and a maximum.
Shall we have such a feature soon?
Regards,
Jean-Marc
Jean-Marc
Newbie
 
Posts: 0
Joined: Tue Sep 08, 2015 11:41 am

Re: Trigger based on two channels at a time

Postby Martyn » Thu Sep 10, 2015 2:43 pm

Depending upon the exact nature of the signals you are looking at it may be possible to do this with the current versions of the software.

Set up a trigger on your primary channel, you can then use the Masks Feature on the secondary channel to give an indication of when the signal is outside of the permitted ranges.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2339
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 0 guests