Test and Measurement Forum

ADC-42 Trigger setup

Post any questions about our parallel port products

ADC-42 Trigger setup

Postby tmcdonagh » Mon Oct 03, 2005 7:34 pm

I have an ADC-42. I would like to trigger collection of data. My equipment puts out a contact closure at the start of a run. Can I utilize this closure to initiate data collection? I also have a ADC-16 serial unit if that will work. My detector puts out 1 volt full scale and another puts out 10 mV full scale.

Best regards,


Postby Michael » Mon Oct 10, 2005 11:27 am


Thank you for your post.
You can record using block mode to make use of triggers.

You will not be able set triggers in real time continuous modes.

Best regards,
Michael - Tech Support
Pico Technology
Web Support Forum
Zen Master
Zen Master
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests