Test and Measurement Forum

Problem with setting trigger from VB in PiccoScope3204

Post general discussions on using our drivers to write your own software here

Problem with setting trigger from VB in PiccoScope3204

Postby tobo » Thu Sep 29, 2005 3:13 pm

Dear Pico Users,

I have a problem for which I can not find a solution. Moreover the helpdesk of Pico is unable to help me either :(

I mean, I need to measure period between CHA & CHB of approx. 4ms.
There should be a trigger set on CHA and later when it is released, samples should be stored in the memory to fetch them later.

I need to configure the trigger as follows: CHA, rising, 900mV.

Then I wrote following command's order:

ps3000_handle = ps3000_open_unit()
i = ps3000_set_ets(ps3000_handle, 0, 0, 0)
Ret = ps3000_set_channel(ps3000_handle, 0, 1, 1, 8 )
Ret = ps3000_set_channel(ps3000_handle, 1, 1, 0, 3)
Ret = ps3000_set_trigger(ps3000_handle, 0, 115, 0, 0, 0)


All is fine but after using ps3000_set_trigger I received "0" so it means that some parameters are out of range. But why?
How can I set the trigger in VB then?

For the response I'd like to thank you in advance!



Best regards,
Tomasz Bobrowski.
tobo
Newbie
 
Posts: 1
Joined: Thu Sep 29, 2005 2:52 pm
Location: Germany

Postby Michael » Mon Oct 10, 2005 10:41 am

Hello Tomasz,

We could only support you to the extent that we have.

If any other user would like to share their knowledge of VB with this user, please do so.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum
Michael
Zen Master
Zen Master
 
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests