PicoScope Progress Dialog

Post general discussions on using our drivers to write your own software here
Post Reply
t-max
User
User
Posts: 2
Joined: Wed Sep 28, 2005 3:55 pm

PicoScope Progress Dialog

Post by t-max » Wed Sep 28, 2005 4:22 pm

Is there a way to disable the progress dialog on the PS-3423 driver?
The software we've written opens the usb scope and collects 20+ samples and then closes the scope and we're getting the dialog opening and closing 20+ times...very annoying and slow. Its three times slower than the old scope we were using.
Thanks!

Michael
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael » Thu Sep 29, 2005 8:56 am

Hello,

Thank you for your enquiry.

It sounds like you are opening and closing the unit for every sample taken. Try opening the unit and looping through the get_values function before closing the unit.

If you would further help, please post your code on this forum. Perhaps others can share their experiences too.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum

t-max
User
User
Posts: 2
Joined: Wed Sep 28, 2005 3:55 pm

Post by t-max » Fri Sep 30, 2005 3:54 pm

Michael,
no, we're only opening the unit once.
We open the scope.
Then we call ready, run_block, and get_times_and_values 20 times.
Then close the unit and we're getting the dialog 20+ times.

Thanks!
~Paul
Michael wrote:Hello,

Thank you for your enquiry.

It sounds like you are opening and closing the unit for every sample taken. Try opening the unit and looping through the get_values function before closing the unit.

If you would further help, please post your code on this forum. Perhaps others can share their experiences too.

Best regards,
Michael

Michael
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael » Mon Oct 10, 2005 10:56 am

Hello,

Please post this fragment of your code. This will help us to diagnose the problem. You can post this direct to us if you wish:
support@picotech.com

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum

Post Reply