ADC-16

Which product is right for your exact requirements
Post Reply
arielmedina61
Active User
Active User
Posts: 21
Joined: Fri Sep 23, 2005 1:17 pm
Location: Buenos Aires-Argentina
Contact:

ADC-16

Post by arielmedina61 » Fri Sep 23, 2005 1:35 pm

I think to buy an ADC-16 to measure two channels simultaneously and then to handle this results with math tools.
Adc-16 acquires simultaneously both channels?

Thank you

Regards

Ariel

Michael
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael » Fri Sep 23, 2005 2:59 pm

Hello,

Thank you for your enquiry.

The ADC16 will monitor all channels for you to perform calculations against using the PicoLog calculated parameters.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum

arielmedina
Active User
Active User
Posts: 17
Joined: Thu Nov 11, 2004 2:40 pm

Post by arielmedina » Tue Sep 27, 2005 2:24 pm

OK, but any channel is acquired at the same time or is there a delay between a channel sample and the following?
Thanks,
Best Regards

Ariel

Michael wrote:Hello,

Thank you for your enquiry.

The ADC16 will monitor all channels for you to perform calculations against using the PicoLog calculated parameters.

Best regards,
Michael

Michael
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael » Wed Sep 28, 2005 2:10 pm

Hello,

The ADC16 uses multiplexing sampling. The sampling rate is 1.5 samples/Sec per active channel. Therefore there will be a small pause between samples that you can calculate using this information.

Please don't hesitate to contact me if you have any further questions.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum

Post Reply