Test and Measurement Forum

Read out the memory data after RunBlock

Post your LabVIEW discussions here

Read out the memory data after RunBlock

Postby aknopf » Mon Aug 17, 2015 11:50 am

Hi,

i work with 4424 picoscope in block mode and now i habe a problem.

I set the setting and segmented the memory in 2 parts. Now i start the process with RunBlock in segment 1 and wait until the run is ready. After the ready signal i want to start a new run in segment 2. In the waiting period i want to read out the data from segment 1 with SetDataBuffer and GetValues. But i get a mistake from GetValues.

Now my question, is it possible to read out the memory data in the waiting period after RunBlock?

Thanks in advance
aknopf
Newbie
 
Posts: 0
Joined: Wed Aug 12, 2015 6:36 am

Re: Read out the memory data after RunBlock

Postby aknopf » Wed Aug 19, 2015 8:01 am

Hallo,

i read in the ps4000 programmer´s guide that you "get the stored data from the scope after data collection has stopped".

Is it right that i can´t start a new RunBlock and in the waiting loop i read the stored data?

Thanks for an answer
aknopf
Newbie
 
Posts: 0
Joined: Wed Aug 12, 2015 6:36 am

Re: Read out the memory data after RunBlock

Postby Martyn » Mon Aug 24, 2015 9:20 am

That's correct, if you have armed the scope to collect data it is not possible to read out data from the other segment.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2287
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to LabVIEW

Who is online

Users browsing this forum: No registered users and 0 guests