Test and Measurement Forum

Picoscope5000 specification compare to IEC61083-1 standard

Post any questions you may have about our current range of oscilloscopes

Picoscope5000 specification compare to IEC61083-1 standard

Postby ahmadtarmimi » Mon Jun 29, 2015 4:06 am

Good Day,

I'm doing testing on high voltage testing or impulse voltage testing using a picoscope5000 series
requirement for the testing is to confirm hardware are complying with IEC61083-1 (hardware requirement for testing in HV for an impulse voltage)
The testing was done using voltage divider and attenuator since voltage range for picoscope +-20VAC/DC

I did some reference check with the IEC standard and Picoscope 5203 and 5244B datasheet but i found some requirement are not written down on the data sheet regarding the hardware

Can you advise for this matter

Attached is also my reference check


Best Regards
Tarmimi
Attachments
cross reference check.gif
ahmadtarmimi
Newbie
 
Posts: 0
Joined: Sun Mar 22, 2015 3:18 pm

Re: Picoscope5000 specification compare to IEC61083-1 standa

Postby Hitesh » Fri Jul 03, 2015 12:49 pm

Hi Tarmimi,

Could you please e-mail this request to support@picotech.com and we will look to assist you further.

Regards,
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2063
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests