Test and Measurement Forum

Triggering my measurement

Post general discussions on using our drivers to write your own software here

Triggering my measurement

Postby CarlG » Wed Apr 15, 2015 11:33 pm

Hi,
I am trying to trigger an eventflow, on my equipment, using my 2204 awg output. The eventflow is then
measured using an input channel, on the same scope, which is beeing trigged by the input signal.
But it seems when I set the out trigger signal the input triggering stoped and no measure is performed.
I have tried to do a workaround using an AWG pulse signal that goes high after a while and before it goes high
I setup the measure settings.This would work but after a single eventflow, I have to turn off the
the pulses to limit it to one pulse. When I do this it seems as if the 2204 sends an extra pulse which
can not be allowed.
Does anyone have suggestion for how to do this?

/Carl
CarlG
Newbie
 
Posts: 0
Joined: Wed Apr 15, 2015 10:57 pm

Re: Triggering my measurement

Postby Martyn » Tue Apr 21, 2015 9:59 am

What language are you programming in ? and if possible can you post your code here or send it to support@picotech.com and we can take a look.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2355
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests