Test and Measurement Forum

hi, question about signal generator

Post any questions about our parallel port products

hi, question about signal generator

Postby guest » Wed Jun 01, 2005 8:01 pm

hi, i was using the signal generator hooking it up to channel B. why is it offset by 0.5V? in settings i had the offset turn off
guest
 

Postby Sarah » Thu Jun 02, 2005 9:14 am

Hi

Thank you for your post.

There should not be an offset on the signal generator. Which unit are you using? What signal generator settings are you using?

Best Regards
Sarah
 

Postby guest » Thu Jun 02, 2005 4:27 pm

3205 , the signal generator settings are 5V Squarewave at 1khz
guest
 

Postby Sarah » Fri Jun 03, 2005 10:06 am

Hi

Thank you for your post and the information.

I have tried this out and do not see an offset with the unit that I used. Could you send me a .psd file showing what you are seeing to tech@picotech.com and also include a link to this thread so that I can check back at what has already been said?

Best Regards
Sarah
 


Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests