Test and Measurement Forum

Position control on the screen

Forum for discussing PicoScope (version 5)

Position control on the screen

Postby arielmedina » Wed Jun 01, 2005 4:12 pm

I using PicoScope 5.11.8 with ADC212/50 in X-Y mode and I want to move the figure both up-down and right-left in the same mode like in a analogue scope using "position" knobs.
Is it possible?

Thanks

Ariel
arielmedina
Active User
Active User
 
Posts: 17
Joined: Thu Nov 11, 2004 2:40 pm

Postby Sarah » Thu Jun 02, 2005 9:16 am

Hi Ariel

Thank you for your post.

You should be able to do this by selecting the x1 zoom for both axis. This then gives you scroll bars on the side which you can use to posistion the figure.

Hope this helps

Best Regards
Sarah
 

Postby arielmedina » Thu Jun 02, 2005 1:17 pm

Hi sarah

Thank you for your reply.

I know the x1 zoom tool for both axis, but when I move the figure , the scale of each axis move too. So I need move only the figure and keep the scale fixed.

Best Regards
Ariel

Sarah wrote:Hi Ariel

Thank you for your post.

You should be able to do this by selecting the x1 zoom for both axis. This then gives you scroll bars on the side which you can use to posistion the figure.

Hope this helps

Best Regards
arielmedina
Active User
Active User
 
Posts: 17
Joined: Thu Nov 11, 2004 2:40 pm

Postby Sarah » Fri Jun 03, 2005 10:08 am

Hi

Thank you for your post.

I do not believe this is possible as if you just move the figure then the readings against the axis will not be correct. Therefore the axis moves with the figure. I do not know of any other way to do this in Picoscope.

Best Regards
Sarah
 

Postby arielmedina » Fri Jun 03, 2005 2:12 pm

Hi,
Thank you for your message.

Sorry, but if you choose any scope (analogue or digital), you can do this. You can move the figure while the scale is static. I know that the "absolute" readings will not be correct, but you can use the cursors to perform relative measures.
On the other hand, I think that I can use the offset null tool to make a little adjust of channels.
So, I would like you take in mind this subject for next upgrade.

Best Regards,

Ariel


Sarah wrote:Hi

Thank you for your post.

I do not believe this is possible as if you just move the figure then the readings against the axis will not be correct. Therefore the axis moves with the figure. I do not know of any other way to do this in Picoscope.

Best Regards
arielmedina
Active User
Active User
 
Posts: 17
Joined: Thu Nov 11, 2004 2:40 pm

Postby Sarah » Tue Jun 07, 2005 9:10 am

Hi

Thank you for yourpost.

I will enter this suggestion into our customer feedback suggestions so that it can be passed on to our development team for consideration.

Best Regards
Sarah
 

Postby arielmedina » Tue Jun 07, 2005 1:38 pm

Hi Sarah,

Thak you very much for your technical assistance.

Best Regards

Ariel

CONIMED SA


Sarah wrote:Hi

Thank you for yourpost.

I will enter this suggestion into our customer feedback suggestions so that it can be passed on to our development team for consideration.

Best Regards
arielmedina
Active User
Active User
 
Posts: 17
Joined: Thu Nov 11, 2004 2:40 pm


Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests