Test and Measurement Forum

Peaks in Picolog

Forum for discussing PicoLog

Peaks in Picolog

Postby gerrit » Sun May 29, 2005 9:57 am

I have an ADC11.
I have two input signals which give a diagram as expected in Picoscope.
If I start up Picolog there appear peak pulses and after collecting some data you can see the peaks in the data sheet.
Switching off Picolog gives a normal diagram in Picoscope again.
I have tried to run Picolog alone, without Picoscope, but the same peaks appear again in the data sheet.
The peaks seem to show at un unregurarely frequency.
I have also tried switching off one of the signals and later switching off the other signal, but the peaks keep appearing.
gerrit
User
User
 
Posts: 2
Joined: Sun Jan 09, 2005 6:02 pm

Postby Sarah » Tue May 31, 2005 10:13 am

Hi

Thank you for your post.

Could you send us some files showing this problem to tech@picotech.com so that we can see what you mean?

Best Regards
Sarah
 


Return to PicoLog

Who is online

Users browsing this forum: No registered users and 0 guests