Test and Measurement Forum

adc11/12 labview

Post your LabVIEW discussions here

adc11/12 labview

Postby pemtek » Mon May 16, 2005 11:47 am

Sorry if this question has been asked previously but I cant get the digital output to work from in labview. Have you got an suggestions? It works fine from excel etc but im really struggling with labview.

Also I have read somewere that there is a second digital output available? Do I have to solder a wire into the pc connector to implement this?

Many thanks

Phil
pemtek
 

Postby Sarah » Thu May 19, 2005 12:37 pm

Hi

Thank you for your post.

The driver calls are the same for excell or for labview, I can only recommend to have a read at the ADC-11_22 manual for full description of the driver calls, it could be a matter of parameter formating?

The second digital out pin in only available on the USB ADC-11, not with the parallel port ADC-11 (even if it used with the USB adapter).

Hope this helps

Best Regards
Sarah
 


Return to LabVIEW

Who is online

Users browsing this forum: No registered users and 1 guest