Post any questions you may have about our current range of oscilloscopes
-
pm_embedded
- Newbie
- Posts: 0
- Joined: Wed Jan 28, 2015 11:56 am
Post
by pm_embedded » Wed Jan 28, 2015 12:22 pm
Looking at an Fullspeed USB communication at the A or B cables connected to analogue channel A and B, SOF, IN and SETUP tokens are viewed fine. However, the DATA 1 frame never ends!?
The fine serial decoding list therefore always ends with a DATA 1 having a very long data field (Although only 8 bytes should de sent).
I look at the A channel USB/Single Ended (Can A and B analyzing be combined as I2C?) 12 Mbaud 1V, 2V Thresholds.
Setting the time rulers does not change/limit the decoding.
I suggest that a data field will be given the ability to terminate itself when a number of FF's occur.
In general the serial analyzer is a very powerful tool 
-
Hitesh
- Site Admin

- Posts: 2847
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Post
by Hitesh » Fri Jan 30, 2015 4:18 pm
Hi pm_embedded,
Could you please send a corresponding data file with the serial decoding set to support@picotech.com or post it here?
We can then take a look at the data and view your settings information.
Thanks,
Hitesh
Software Dev. Engineer