Test and Measurement Forum

Pulse Sync with PicoScope 3000

Which product is right for your exact requirements

Pulse Sync with PicoScope 3000

Postby gbehringer » Wed Mar 30, 2005 5:29 pm

Hello,
I would like to sync to a pulse being measured by the PicoScope. Is there an output where this can be done, or is it necessary to try to use the streaming data values in the software.

Thank you,
gbehringer
gbehringer
 

Postby Sarah » Thu Mar 31, 2005 9:01 am

Hi

Thank you for your post.

Are you meaning that you want to sync the Picoscope, or something else to this pulse? It is not possible to sync the Picoscope to a pulse.

There is no output on the Picoscope with exception to the signal generator, this however cannot not provide any other type of output. Would it be possible for you to use a T-juntion to take the pulse from the source to both the Picoscope and the device you wish to sync?

Hope this helps

Best Regards
Sarah
 


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests