Test and Measurement Forum

ADC100 Pico Log/Player confusion

Forum for discussing PicoLog

ADC100 Pico Log/Player confusion

Postby Wavelength » Thu Mar 17, 2005 9:33 pm

I have PicoLog and PicoPlayer installed on the same XP based machine.
If I run PicoLog then shut it down, the next time I try to run PicoLog, I have a problem because PicoPlayer runs instead?.

If I reboot the machine its OK and PicoLog runs on demand (first time only then reverts to PicoPlayer)

Anyone else seen this problem?

Postby Sarah » Fri Mar 18, 2005 9:42 am


Thank you for your post.

Picolog opens the player when the recorder has not been shut down, therefore for some reason it is not closing properly.

If you are using a USB device try unplugging that from the USB port. You may need to go into the task manager (by doing Ctrl+Alt+Del) and find the process plw32.exe and end the task from there. This should then allow you to open the recorder without problems.

Hope this helps

Best Regards

Return to PicoLog

Who is online

Users browsing this forum: No registered users and 1 guest