Test and Measurement Forum

Need help with Picoscope experiment

Forum for discussing PicoScope version 6 (non-automotive version)

Need help with Picoscope experiment

Postby LividBark » Mon Nov 10, 2014 9:34 am

Hey guys,
So I'm doing an experiment in Physics and it involves having to drop a magnet down a tube, going through two coils which send a signal to the PicoScope software which will allow me to determine 'g'. I have no problem setting up the physical equipment, however I have never used this software before and was wondering if someone could tell me how I would be able to set it up to do this (I only know I need to use a 'Single Trigger Event')

Here is a link to the experiment: http://www.picotech.com/experiments/gra ... celeration

Thanks a lot.
Posts: 0
Joined: Mon Nov 10, 2014 9:19 am

Re: Need help with Picoscope experiment

Postby Hitesh » Thu Nov 13, 2014 12:02 pm

Hi LividBark,

I would suggest adjusting the collection time/timebase and the number of samples collected per waveform (highlighted in yellow in the image of a PicoScope 6 display below).

PicoScope 6 Display

Which version of the software and PicoScope device are you using?

There are a number of videos available that show how to use PicoScope 6 features such as


Technical Specialist
Pico Technology
Site Admin
Site Admin
Posts: 2023
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 1 guest