pt104

Which product is right for your exact requirements
Post Reply
ricewind

pt104

Post by ricewind » Thu Mar 10, 2005 11:53 am

can i place a pt500 on this product if i change the caculation in the software?

Sarah

Post by Sarah » Fri Mar 11, 2005 10:23 am

Hi

Thank you for your post.

You could potentially use PT500 sensors with the PT104 if the output voltage is in the same region then you could connect them and use the voltage measurement of the unit. You could then enter scaling information into the software.

Hope this helps

Best Regards

ricewind
User
User
Posts: 4
Joined: Thu Mar 10, 2005 11:55 am
Location: lancaster
Contact:

Post by ricewind » Mon Mar 14, 2005 8:50 am

cheers i will have a go and see what happens.

Goran Ericsson

PT-104 and Linux

Post by Goran Ericsson » Wed Mar 23, 2005 4:04 pm

I'd like to use the PT-104 instrument in a Linux based custom application. Can you provide the necessary information to make that possible?

Sarah

Post by Sarah » Thu Mar 24, 2005 10:34 am

Hi

Thank you for your post.

Unfortunately we do not at present have a Linux driver for the PT104. We supply some drivers for some of our units as a service, however cannot guarantee to be able to support them.

Therefore I can unfortuantely offer no drivers or advice on using a PT104 on Linux.

Best Regards

Post Reply