Hi,
I have been using a PT104 in Ethernet mode.
To enter Ethernet mode (once configured and connected) I must first power the unit via USB then quickly remove and reinsert the USB power to wake/enable the Ethernet. If this process is performed slowly then the unit simply powers down. Done quickly the Ethernet LEDs come on and Ethernet communication is possible.
I wish to uses this device remotely and will have power control via an ethernet power distribution unit (pdu) to cycle the power to the PT104 if required. My problem is that the PDU cannot perform the power cycle sequence required to enable Ethernet mode.
Can the PT104 be configured to default to ethernet mode on power-up. Enabling Ethernet Setting using the Ethernet Settings application does not achieve this.
Thanks
David