Test and Measurement Forum

Scaling of Y-axis in software V6.9.14.16

Forum for discussing PicoScope version 6 (non-automotive version)

Scaling of Y-axis in software V6.9.14.16

Postby Picolor » Mon Aug 11, 2014 11:13 am

We only need positive voltages, but the software only displays the half of the disposal surface.
One half is positive and the other half is negative. When we scale it, that the zero point is below, the 20V point is in the half of the display and the other half is unused. Is it possible to display only positive voltages over the complete surface?

regards
thomas
Picolor
Newbie
 
Posts: 0
Joined: Fri Aug 08, 2014 11:20 am

Re: Scaling of Y-axis in software V6.9.14.16

Postby bennog » Mon Aug 11, 2014 3:28 pm

If you press the blue rectangle on the bottom left (with the x1.0 in it)
You can set the settings like below and you can use the full screen (you only use 7 of the 8 bits) or (11 of the 12) depending on the scope you use.
Scale 2.0

11-8-2014 17-23-28.jpg


Regards,
Benno
bennog
Guru
Guru
 
Posts: 79
Joined: Mon Nov 26, 2012 9:16 am


Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 0 guests