Pulse width trigger failing in 6.8.11 with 3404A

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
mike thomas
Newbie
Posts: 0
Joined: Thu Mar 14, 2013 5:24 pm

Pulse width trigger failing in 6.8.11 with 3404A

Post by mike thomas » Tue Jul 01, 2014 9:37 pm

Somewhere between Picoscope 6.8.3 and 6.8.11 the pulse width triggering for the 3404A 4-channel scope has been partially broken.
With the earlier software all works as expected.
With the later software, when triggering from C or D the pulse width triggering only works when no more than two channels are enabled. When three or four channels are enabled, the 'greater than' trigger never fires, and the 'less than' trigger fires for any pulse width.

Mike.

Hitesh
Site Admin
Site Admin
Posts: 2829
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Pulse width trigger failing in 6.8.11 with 3404A

Post by Hitesh » Wed Jul 02, 2014 10:01 am

Hello Mike,

Could you please send data files with the settings that you have used you have used for the Pulse Width trigger to support@picotech.com.

This will enable us to investigate further.

Many thanks,
Hitesh

Technical Support Engineer

Post Reply