Test and Measurement Forum

Temperatur loggoing using the ADC 10/11

Which product is right for your exact requirements

Temperatur loggoing using the ADC 10/11

Postby MIKEUK » Thu Feb 17, 2005 1:14 pm

How would I attach thermocouples to this ADC 10/11?
MIKEUK
 

Postby Sarah » Fri Feb 18, 2005 10:33 am

Hi

Thank you for your post.

I would not recommend connecting thermocouples to an ADC10 or 11 as the resolution of these units is not sufficient to see the small changes in voltage exhibited by thermocouples.

Instead I would recommend our TC-08 unit as this is built for use with thermocouples and has the right input voltage range needed to see the small changes of thermocouple outputs. It can accept any type of thermocouple and will do all the necessary scaling in the software.

Hope this helps

Best Regards
Sarah
 


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 0 guests