Ext Trigger on 3206

Forum for discussing PicoScope (version 5)
Post Reply
Posts: 2
Joined: Thu Feb 10, 2005 8:16 pm

Ext Trigger on 3206

Post by tss » Wed Feb 16, 2005 12:50 pm

is it possible to send a PULSE OUT of the picoscope via the Ext port when a defined trigger event occurs on channel A or B?

if so, what is the level and what are the pulse characteristics?



Post by Sarah » Fri Feb 18, 2005 9:53 am


Thank you for your post.

The only signal you can send out from the Ext port is from the signal generator. Therefore you could set it to be giving out a square wave to get pulses, however you cannot get it to give out just one pulse.

The square wave can be set from 1Hz to 1MHz and is 5V pk-pk.

Hope this helps

Best Regards

Post Reply