Test and Measurement Forum

storing signal generator settings?

Forum for discussing PicoScope version 6 (non-automotive version)

storing signal generator settings?

Postby user4262 » Sun May 04, 2014 6:29 pm

The software doesn't store the last adjustment of the signal generator (scope 4262, SW 6.8.11).

So the worklow is as below described:
- I have allways first enable the generator with the default (1V, 1k, Square)
- then I can adjust the amplitude, signal...

For some DUT the default signal can be to high. So I first disconnect the DUT, enable the generator and adjust then the signal. :shock: Then I reconnect the DUT.

Is it possible to store the last generator settings?
Posts: 0
Joined: Sun May 04, 2014 6:15 pm

Re: storing signal generator settings?

Postby Hitesh » Wed May 07, 2014 8:08 am

Hi user4262,

You can save your current PicoScope 6 settings to a .pssettings file by clicking File -> Save As... and selecting 'Settings files (*.pssettings)' in the 'Save as type' drop-down.

You can then load this file into PicoScope 6 either by double-clicking it to start a new instance or via the File -> Open... menu.

I hope this helps.

Technical Specialist
Pico Technology
Site Admin
Site Admin
Posts: 2032
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 0 guests