Power waveforms

Which product is right for your exact requirements
Post Reply
dudrik

Power waveforms

Post by dudrik »

Hi! I have two questions to the same problem - multiplication of waveforms:
1. Is it possible to multiplicate two waveforms ( voltage and current) to obtain power waveform ?
2. Is it possible to change the quantity ? For example, if the current is sensed by current probe then the output is ussualy in 10mV input range of oscilloscope. Can I change this letś say to 10A ? and obtain power in Watts? Thanks!

Sarah

Post by Sarah »

Hi

Thank you for your post.

It is not possibl to do what you descibe in Picoscope, however you can do it in Picolog.

In Picolog you can scale the results you recieve so that a 10mA signal could display as 10A. You can also then set up "Calculated Parameters" which enable you to multiply together (or add, subtract etc) the results from different inputs.

Hope this helps

Best Regards

Post Reply