Test and Measurement Forum

Picoscope USB streaming with linux

Discussion forum for the new Picoscope Linux software

Picoscope USB streaming with linux

Postby robertolulli » Tue Feb 04, 2014 5:37 pm

Dear all,
I need to use Picoscope as an acquisition board. What is the maximum sample rate that I can archieve with USB 3.0 models (3207 A/B). My application use only one channel, I have no problems with CPU load and I don't need to connect any other device to USB BUS.

Regards,

Roberto Lulli
robertolulli
Newbie
 
Posts: 0
Joined: Tue Feb 04, 2014 5:27 pm

Re: Picoscope USB streaming with linux

Postby Martyn » Thu Feb 06, 2014 8:12 am

There is no set answer to this, it will depend upon the PC specification, how the USB3 is connected within the system (motherboard/PCIe), and system load.

We have seen from 80MS/s through to 180MS/s on lightly loaded Windows PC's using the same test code, so I would expect a similar range on Linux.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2339
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to PicoScope for Linux

Who is online

Users browsing this forum: No registered users and 0 guests