Test and Measurement Forum

Serial TC-08 driver

Post your LabVIEW discussions here

Serial TC-08 driver

Postby ka_torce » Thu Nov 28, 2013 12:13 pm

Hello,

I have downloaded the Software development Kit R1.0.0 available for the Serial Tc-08 product from:
http://www.picotech.com/software.html

but when I try to open the vi files in labview 2011 it says that cannot run it since it was built using Labview 4 which is quite old.
Can you please provide an updated vi example for using the Serial TC-08 with Labview.

Thank you.
regards.
ka_torce
Newbie
 
Posts: 0
Joined: Thu Nov 28, 2013 12:08 pm

Re: Serial TC-08 driver

Postby Hitesh » Fri Nov 29, 2013 2:09 pm

Hi ka_torce,

If you have access to an early version such as LabVIEW 7.1 you can open the vi file and save it for that version. You should then be able to open this in LabVIEW 2011.

This webpage may be of interest:

http://www.ni.com/white-paper/8387/en/

If you are not able to do this above, then please post back here.

Thanks,
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2063
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Serial TC-08 driver

Postby ka_torce » Mon Dec 02, 2013 1:55 pm

Hello,

thanks for your answer but unfortunately I do not have access to previous Labview versions. Any option?
Thank you.
Regards.
ka_torce
Newbie
 
Posts: 0
Joined: Thu Nov 28, 2013 12:08 pm

Re: Serial TC-08 driver

Postby Hitesh » Mon Dec 02, 2013 2:11 pm

Hi ka_torce,

I will look into this further.

Another option is to use the serial protocol for the device which is provided in section 3.4 in the Programmer's Guide.

Regards,
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2063
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to LabVIEW

Who is online

Users browsing this forum: No registered users and 0 guests