Test and Measurement Forum

Scaling on graphs

Forum for discussing PicoScope version 6 (non-automotive version)

Scaling on graphs

Postby pwright » Mon Nov 11, 2013 9:27 am

Hi,

I've continued some testing from a few months back with the same gear and have got very different answers. This time I created a custom probe to output my results directly in kN. Last time I left them in V (converting later), but I think I may have used x100 probe. Is there anyway I can confirm this from the .psdata file graph? e.g. the resolution?
Thanks
Phil
pwright
Newbie
 
Posts: 0
Joined: Mon Sep 16, 2013 11:10 am

Re: Scaling on graphs

Postby Martyn » Fri Nov 15, 2013 8:23 am

If you open up PicoScope 6 and then load the psdata file and take a look at the probe it should tell you what was used when the readings were taken.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2355
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 1 guest