Test and Measurement Forum

Vp-p and Phase Measurement in VB

Forum for discussing PicoScope (version 5)

Vp-p and Phase Measurement in VB

Postby JSmith » Wed Jan 12, 2005 4:02 am


Is there a command or line of code in VB for the PicoScope 3000 series that can measure Vp-p?

Same question but for measuring the phase between two inputs?

Active User
Active User
Posts: 6
Joined: Tue Dec 07, 2004 3:14 am

Postby Sarah » Wed Jan 12, 2005 11:09 am


Thank you for your post.

Unfortunately there is not a function that will provide the Pk-to-Pk
voltage. The only results obtainable from the unit are ADC counts these results being proportional to the voltage range set in ps3000_set_channel, and the time each sample was take, with the first sample being 0, unless a post or pre trigger is in use. All manipulation of the raw values are left up to the user.

Hope this helps

Best Regards

Return to PicoScope 5

Who is online

Users browsing this forum: No registered users and 0 guests